10HP LIQUID PUMPS OVERVIEW
Haskel 10HP Liquid Pumps are designed to provide a safe, reliable and economical, source of hydraulic pressure.
Key Features:
- Choice of 4 models, 4 ratios, 4 possible combinations
- Flows to 3 GPM
- Choice of wetted materials
- Double-acting single air head
- Air drive pressure 3 to 125 psi
- Output pressures to 36,000 psi (outlet pressure = air drive pressure x pump pressure ratio)
- All hydraulic fluids, water (plain or DI), solvents, liquefied gases
- Max cycle rate = 40 cycles per minute
Connections:
- Air inlet: 3/4″ FNPT
- Liquid inlet: 2x 1/2″ FNPT
- Liquid outlet: 2X 3/8″ HP
10HP Liquid Pumps Model Selection Chart
Service
Codes
Pump
Section
Plunger
Non-Metallics
Pressure Ratios
1,2,3,5A,6
All Stainless Steel & Bronze
Tungsten-Carbide coated 15-5PH SS
UHMWPE, Viton, PTFE, Ryton
-125
1,2,3,5A,6
All Stainless Steel & Bronze
Tungsten-Carbide coated 15-5PH SS
UHMWPE, Viton, PTFE, Ryton
-315
Service Codes Breakdown:
- Petroleum-based oils, kerosene, ethylene glycol, water with 5% soluble oil.
- Plain water, diesel fuel.
- Most phosphate ester-based hydraulic fire-resistant hydraulic fluids.
- Petroleum-based solvents.
- Skydrol and Aerosafe hydraulic acetone and some alcohols. 5A: also suitable for these fluids if Viton static seals are replaced with EPR; specify modification number 51331 (no additional charge).
- Deionized water; demineralized water.
For assistance with or additional information on any of these products, please contact sa***@fl*****************.com .